Customise Consent Preferences

We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.

The cookies that are categorised as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ... 

Always Active

Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.

No cookies to display.

Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.

No cookies to display.

Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.

No cookies to display.

Performance cookies are used to understand and analyse the key performance indexes of the website which helps in delivering a better user experience for the visitors.

No cookies to display.

Advertisement cookies are used to provide visitors with customised advertisements based on the pages you visited previously and to analyse the effectiveness of the ad campaigns.

No cookies to display.

Welcome to SNEAKTECH, One Stop Shop For All Your Gaming Needs!
Masta-Blasta for Flipper Zero

$55.00

Description

Description

Infrared (IR) blaster addon for the Flipper Zero. 12 IR High-Intensity LEDs with specific focus to create a “beam” of high-intensity IR Light. This Blaster had it’s IR LED Placement designed specifically to allow for the addition of a lens to further improve performance. Lets you control TVs, Projectors, A/V Equipment, wall AC units, fans, heaters, and much more using the flipper as an “universal remote”.

Also has built-in reverse polarity protection to prevent damage to the flipper if inserted backwards.

When running unofficial firmware, you can turn on the “Debug IR” feature which will allow you to use this module. This will allow you to transmit at a might higher power than the built-in IR, which means you can turn on / off devices without having to point the flipper at the device directly.

  • You must enable “Debug” mode: go to settings —> system —> debug —> ON
  • You must also enable 5v mode: go to GPIO —> 5v –> ON

Flipper Zero required. Flipper Zero not included.