This CAN bus addon for the Flipper Zero features the MCP2515 chip which allows you to read messages that are transmitted, watch bytes from every node in the network, and catch any message/package to then resend it or send other data to the same address.

The required MCP2515-CANBUS flipper app is the tool for analysis, error detection and peripherals control in a CAN bus network.

Infrared (IR) blaster addon for the Flipper Zero. 12 IR High-Intensity LEDs with specific focus to create a “beam” of high-intensity IR Light. This Blaster had it’s IR LED Placement designed specifically to allow for the addition of a lens to further improve performance. Lets you control TVs, Projectors, A/V Equipment, wall AC units, fans, heaters, and much more using the flipper as an “universal remote”.

Also has built-in reverse polarity protection to prevent damage to the flipper if inserted backwards.

When running unofficial firmware, you can turn on the “Debug IR” feature which will allow you to use this module. This will allow you to transmit at a might higher power than the built-in IR, which means you can turn on / off devices without having to point the flipper at the device directly.

• You must enable “Debug” mode: go to settings —> system —> debug —> ON
• You must also enable 5v mode: go to GPIO —> 5v –> ON

Flipper Zero required. Flipper Zero not included.

Flipper Zero is a portable multi-tool for pentesters and geeks in a toy-like body. It loves hacking digital stuff, such as radio protocols, access control systems, hardware and more. It’s fully open-source and customizable, so you can extend it in whatever way you like.

Features: Sub 1-ghz transceiver, 125kHz RFID, 13.56 MHz NFC, Bluetooth, Infrared Transceiver, 1-Wire iButton, expansion headers.

You can read more about the device at https://flipperzero.one/